Honeywell TC-FPCXX2 Power Supply Module in stock

Power Supply Module Models:

• Uncoated Models:

• TC-FPCXX2

• TC-FPDXX2

• Coated Models:

• TK-FPCXX2

• TK-FPDXX2

Electrical Specifications:

• Input Voltage Range:

• 85-132 VAC or 170-265 VAC (selectable)

• 19.2-32 VDC

• Note: Input may drop to 16 V for a maximum of 2 minutes each hour for motor starting.

• Input Power:

• 150 VA, 92 W for TC-FPCXX2

• 100 W for TC-FPDXX2

• Maximum Inrush Current:

• 15 A for TC-FPCXX2

• 30 A for TC-FPDXX2

• Frequency Range:

• 47-63 Hz for AC

• DC for DC input

Output Specifications:

• Total Power Output (maximum):

• 70 W @ 60°C

• Backplane Output Current (maximum):

• 1.5 A @ 1.2 V

• 4 A @ 3.3 V

• 10 A @ 5.1 V

• 2.8 A @ 24.0 V

• Note: The combination of all output power cannot exceed 70 W.

Physical Specifications:

• Fuse Protection:

• Non-replaceable fuse soldered in place, intended to guard against fire hazards due to short circuit conditions.

• Wiring:

• #14 AWG (1.4 mm)

• Dimensions (L x D x H):

• 11.2 x 14.5 x 14.0 cm (4.41 x 5.71 x 5.51 in)

• Weight:

• Approx. 1.1 kg (2.5 lb.)

• Location:

• Left side of chassis (does not consume a slot)

Additional Notes:

• Earlier models were rated as follows:

• TC-FPCXX1: 55 W @ 60°C; 70 W @ 45°C

• TC-FPDXX1: 50 W @ 60°C; 70 W @ 40°C

Why do they ? 

Prerequisites • These procedures can only be performed while off process. • We recommend that you proceed with extreme caution whenever replacing any component in a control system. • Be sure the system is offline or in a safe operating mode. • Component replacements may also require corresponding changes in the control strategy configuration through Control Builder, as well as downloading appropriate data to the replaced component. • Note that all modules are keyed. 1 Loosen screws at each side of the module cover that secures the controller module to the IOTA board. 2 Carefully remove the Controller module from the IOTA board and connector.